hi, folks. i finally decided to disassemble the trigger assembly on my super streak. as i had figured, all 3 parts of the trigger were in dire need of de-burring and polishing. it all went well until i went to put the thing back together. maybe im just stupid or perhaps i overestimated the simplicity of this project, but i have all parts where they should be yet i cant seem to get either of the springs in there to do their job. anyway, if anybody could give me a step by step guide to reassembly of this type of trigger, perhaps with a few pics, it would be greatly appreciated. thanks -matt

I used http://www.charliedatuna.com/airgun_docs/B19%20Super%20Tune.doc Charlie da tuna's doc to reassemble my big cat trigger assembly. Not sure if it's the same for the super streak. Look for the trigger diagram.

Contact Rich from MI and he has a part that will make it better. He can get you straitened around.

Let me see what I can do. I have a spare trigger pack laying around. I should have something up for you tomorrow...

cool. thanks alot, guys.... ive got an update... fashoned a bootleg spring compressor from a couple old pipe clamps and ive now got the whole gun taken down and ready for a complete tune! the factory lubricants inside are freaking pathetic! its like they just poured a bunch of low grade used motor oil inside the gun and threw it together... i just wish i still had that tube of militech 1 rifle grease and that jar of moly paste to use... all ive got now is some thick brown grease called darna-ax.

Here you go - it's now in the library:

http://www.airgunone.com/forums/showthread.php?t=656

cool. thanks.