Benjamin Regal NP .22 Cal Zero Scope problem
First I want to say is that I am new to Air Rifles and new in this forum. I will take whatever help some one can reply.
So I purchased a Benjamin Regal NP .22 (break barrel) week before Christmas as my gift to my self, I immediately started to read instructions and assembling it. So after a month or so of using it I am confident on how to use aim center scope etc... and I found it's ups and downs.
The Benjamin Regal NP is only sold in Big 5, it's a cross between a trail and discovery as far as I know. You can choose a .177 or a .22 I went with .22.
So here is my problem I am having if any one can give me some advice. I have the gun strapped down on a jig I made to center it, I manage to center it fine at any distance up to 60yards it's the longest flattest space we have. Now after it's centered I feel happy, but I keep shooting at the target and the shots start going all over the place then it stops and the shot's now have a new place that they keep landing so I center it again.
Now remember I have it strapped and aimed at a point in one location always. If I take it off it will keep pointing on the same location with my scope. At first my scope slid all the way to the back so I left it nice and secured to the back of the mount (no more sliding) The gun has a small recoil not too bad.
-Cleaned the barrel as instructed
-Centered the Scope at least a few dozen times already
-Put my scope all the way to the back of the rail so it would stop sliding
-I have fired more than 1000+ shot's already so it should of plateaued on the speed that they exit
-I have not had any major drop on it, it has slid from a leaning position and landed on it's scope at least one time that i can remember.
-No modifications done to gun or scope
That's all the information I can think of, But I can reply to any additional questions you can think of, or any help you can give me.